User talk:Vazhnov/My hardware

From Gentoo Wiki
Jump to:navigation Jump to:search
Note
Before creating a discussion or leaving a comment, please read about using talk pages. To create a new discussion, click here. Comments on an existing discussion should be signed using ~~~~:
A comment [[User:Larry|Larry]] 13:52, 13 May 2024 (UTC)
: A reply [[User:Sally|Sally]] 05:06, 12 November 2024 (UTC)
:: Your reply ~~~~

AMD Phenom II X6 1055T with DDR3

Talk status
This discussion is done.

Hi. I used to run this combo before and one observation from when I switch from DDR2 was an increased heat load on the CPU. I switched to an AIO cooler and it stabilized a lot more. The old cooler I had prior would cause thermal shutdowns. A high end air cooler may also do the job but I have not tested. --Grknight (talk) 12:36, 4 July 2021 (UTC)

I will try with another cooler, thank you! Currently I found my CPU works fine with DDR3 ECC (even in non-ECC mode). But when I use more than 1 non-ECC DDR3 stick, the motherboard boots only once after CMOS reset (as I know, because in this case it always uses only first DRAM module), but then after reboot, the motherboard just stops doing anything. --Vazhnov (talk) 14:57, 12 July 2021 (UTC)
No success. If DDR3, then ECC only. --Vazhnov (talk) 21:41, 16 July 2022 (UTC)