Handbook:IA64/Blocks/Kernel
From Gentoo Wiki
Jump to:navigation
Jump to:search
Architecture specific kernel configuration
Select the correct system type and processor type. DIG-compliant is a good default choice. When installing on an SGI system make sure to select the SGI system type, the kernel may just lock up and refuse to boot otherwise.
System type --->
(Change according to the system)
DIG-compliant
Processor type --->
(Change according to the system)
Itanium 2
Compiling and installing
With the kernel configured, it is time to compile and install it. Exit the configuration and start the compilation process:
root #
make && make modules_install
Note
It is possible to enable parallel builds using
It is possible to enable parallel builds using
make -jX
with X being the number of parallel tasks that the build process is allowed to launch. This is similar to the instructions about /etc/portage/make.conf earlier, with the MAKEOPTS
variable.When the kernel has finished compiling, copy the kernel image to /. Use whatever name is appropriate for your kernel choice and remember it as it will be referred to later on when configuring the bootloader. Remember to replace vmlinuz with the name and version of the installed kernel.
root #
cp vmlinux.gz /boot/vmlinuz