Architecture specific kernel configuration
Make sure to select IA32 Emulation and 32-bit time_t if 32-bit programs should be supported (CONFIG_IA32_EMULATION and CONFIG_COMPAT_32BIT_TIME). Gentoo installs a multilib system (mixed 32-bit/64-bit computing) by default, so unless a no-multilib profile is used, these options are required.
Processor type and features ---> [ ] Machine Check / overheating reporting [ ] Intel MCE Features [ ] AMD MCE Features Processor family (AMD-Opteron/Athlon64) ---> ( ) Opteron/Athlon64/Hammer/K8 ( ) Intel P4 / older Netburst based Xeon ( ) Core 2/newer Xeon ( ) Intel Atom ( ) Generic-x86-64 Binary Emulations ---> [*] IA32 Emulation General architecture-dependent options ---> [*] Provide system calls for 32-bit time_t
Enable GPT partition label support if that was used previously when partitioning the disk (CONFIG_PARTITION_ADVANCED and CONFIG_EFI_PARTITION):
-*- Enable the block layer ---> Partition Types ---> [*] Advanced partition selection [*] EFI GUID Partition support
Enable EFI stub support, EFI variables and EFI Framebuffer in the Linux kernel if UEFI is used to boot the system (CONFIG_EFI, CONFIG_EFI_STUB, CONFIG_EFI_MIXED, CONFIG_EFI_VARS, and CONFIG_FB_EFI):
Processor type and features ---> [*] EFI runtime service support [*] EFI stub support [*] EFI mixed-mode support Device Drivers Firmware Drivers ---> EFI (Extensible Firmware Interface) Support ---> <*> EFI Variable Support via sysfs Graphics support ---> Frame buffer Devices ---> <*> Support for frame buffer devices ---> [*] EFI-based Framebuffer Support
Compiler et installer
With the configuration now done, it is time to compile and install the kernel. Exit the configuration and start the compilation process:
make && make modules_install
It is possible to enable parallel builds using make -jX with
Xbeing an integer number of parallel tasks that the build process is allowed to launch. This is similar to the instructions about /etc/portage/make.conf earlier, with the MAKEOPTS variable.
When the kernel has finished compiling, copy the kernel image to /boot/. This is handled by the make install command:
This will copy the kernel image into /boot/ together with the System.map file and the kernel configuration file.