Translations:Iwlwifi/30/zh-cn

user $dmesg | grep -i -E '03:00.0|wlp|iwl|80211'

[    1.200902] pci 0000:03:00.0: [8086:0082] type 00 class 0x028000
[    1.201065] pci 0000:03:00.0: reg 0x10: [mem 0xf7d00000-0xf7d01fff 64bit]
[    1.201776] pci 0000:03:00.0: PME# supported from D0 D3hot D3cold
[    1.201999] pci 0000:03:00.0: System wakeup disabled by ACPI
[   18.260461] iwlwifi 0000:03:00.0: enabling device (0100 -> 0102)
[   18.260598] iwlwifi 0000:03:00.0: can't disable ASPM; OS doesn't have ASPM control
[   18.419884] iwlwifi 0000:03:00.0: loaded firmware version 18.168.6.1 op_mode iwldvm
[   18.671329] iwlwifi 0000:03:00.0: CONFIG_IWLWIFI_DEBUG enabled
[   18.671330] iwlwifi 0000:03:00.0: CONFIG_IWLWIFI_DEBUGFS enabled
[   18.671330] iwlwifi 0000:03:00.0: CONFIG_IWLWIFI_DEVICE_TRACING disabled
[   18.671332] iwlwifi 0000:03:00.0: Detected Intel(R) Centrino(R) Advanced-N 6205 AGN, REV=0xB0
[   18.673421] iwlwifi 0000:03:00.0: L1 Enabled - LTR Disabled
[   18.705882] ieee80211 phy0: Selected rate control algorithm 'iwl-agn-rs'
[   18.706468] iwlwifi 0000:03:00.0 wlp3s0: renamed from wlan0
[   23.286871] IPv6: ADDRCONF(NETDEV_UP): wlp3s0: link is not ready
    ......... snip .........
[   48.176954] IPv6: ADDRCONF(NETDEV_UP): wlp3s0: link is not ready
[   92.720710] wlp3s0: authenticate with my WLAN AP
[   92.724440] wlp3s0: send auth to my WLAN AP (try 1/3)
[   92.728436] wlp3s0: authenticated
[   92.728646] wlp3s0: waiting for beacon from my WLAN AP
[   92.821389] wlp3s0: associate with my WLAN AP (try 1/3)
[   92.828148] wlp3s0: RX AssocResp from my WLAN AP (capab=0x431 status=0 aid=4)
[   92.853124] wlp3s0: associated
[   92.853173] IPv6: ADDRCONF(NETDEV_CHANGE): wlp3s0: link becomes ready