Cubietruck
From Gentoo Wiki
Cubietruck is the third generation of the famous Cubieboard, and is the most full-featured board to date. It has a dual-core ARM SoC (Allwinner A20, ARMv7a) with 2 GB DDR3 RAM and uses a microSD(HC) card or 8 GB NAND for storage. Also, there are TSD versions out there.
Hardware
Component status
| Device | Make/model | Works | Notes |
|---|---|---|---|
| SoC | Works | ||
| Video | Mali 400 MP2 | Not tested | |
| Audio | Works | ||
| Ethernet | Realtek RTL8211E | Works | |
| 802.11b/g/n WLAN | Ampak AP6210 | Works | brcm/brcmfmac43362-sdio.cubietech,cubietruck.txt of linux-firmware is required |
| USB Controller (Host) | Works | ||
| USB Controller (OTG) | Works | ||
| NAND | Not tested | ||
| SATA | Works | ||
| microSD | Works | ||
| Hardware monitoring | Not tested | ||
| GPIO | Not tested | ||
| LED control
(blue, green, orange, white) |
Works | Manipulate through /sys/class/leds/ | |
| IR (Infrared) input | Not tested |
Installation
For installation the u-boot environment and kernel must be built and then written to the microSD card.